Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey
Thruster TPV Grips - Grey

Thruster TPV Grips - Grey

SKU: 6702-0501
CHF 18.00
FREE SHIPPING OVER $149 IN CONT. USA

SENT
SUCCESFULLY!

We will notify you at the email address when the product is available again.

In stock
Size:1"
Dimensions

Thruster uses the same padded diamond surface as our Torker grip, but features a tall inside flange and thick molded end cap for a retro MX look and feel.

 

Dimensions

Thruster TPV Grips - Grey

TECH SPECS
INSTALL TIPS
  • Injection-molded Thermoplastic Vulcanizate synthetic rubber is soft, durable and highly UV-resistant
  • Thick one-piece molded end design for durability
  • Tall inner flange protects your hands from discomfort against throttle and hand controls
  • Safety wire grooves for added security
  • Aftermarket throttle tube required to install Biltwell grips on stock H-D hand controls—see our Whiskey Throttle


Counterintuitive though it might seem, aerosol WD-40 spray lubricant is our chemical of choice for installing Biltwell molded TPV grips. "But it's oil!" you say. Yes, but WD-40's combination of aerosol propellant and organic-based lubricant is perfect for sliding tight grips onto clean metal tubes. A quick 1- or 2-second blast into the open end of the grip is all it takes. Once installed, WD-40's chemical compound melts the grip interior just enough to make it stick to the bar like glue, without the mess. IMPORTANT: Wait 24 hours after installation before riding to give grips sufficient time to set up on the bars. Immediately after installation you can add safety wire wraps to both ends of the grips; this old motocross trick works great to reduce grip slip on the bars and throttle tube.